Skip to content

Z5R-Net

General Info

The controller is designed to control access to living and industrial premises, time tracking and other events. The controller can operate both autonomously and as part of a network. By connection and work in stand-alone mode the controller Z-5R Net(8000) allows you to connect the following equipment:

  • protocol reader for proximity cards iButton and Wiegand26
  • contact key reader - contactor
  • electromagnetic lock, electromechanical lock / latch
  • lock opening button (normally open)
  • external buzzer, external LED (analogs to those installed on the board controller);
  • open door sensor (normally open type) Connecting to the card reader controller can be made both by protocol and by Wiegand26.

Specifications

Maximum number of keys: up to 8168 pcs

Jumper to select the type of lock: included

Setting the duration of opening the lock: from 0 to 2 sec (factory setting - 3 sec)

Working voltage: 12V DC

Consumption current (standby mode): 30mA

Wrong inclusion protection: included

Indication of operating modes and programming: light and sound

Front end: RS-485

Remote controller over RS-485: up to 1200m

Power output: MIS transistor up to 5A

Body material: ABS plastic

Board size: 60х50х12mm

Weight: 80g

Reader Operation

Short beeps are emitted for 16 seconds. Which indicates that the memory has been erased and the mode is set. adding master keys. At the moment of issuing signals, touch the contactor with the key, this will lead to recording it into memory as a master key. Termination of short beeps is a confirmation successful writing of the first master key. To add new master keys, touch them in turn contactor with a pause between touches of less than 16 seconds. For each touch with a new key, the controller issues a short confirmation signal. Exiting the mode. Master keys are added automatically 16 seconds after the last touch. About the exit from the mode the controller informs with a series of 4 short signals. Further for programming master keys are used. If no keys have been written, try turning on again. Entering the mode recording of the master key when power is applied occurs only when the base is completely empty (no simple, no master, no blocking keys).